M5-0.8 Short Brass Threaded Inserts – Initeq

4.6 (188) · € 47.00 · En Stock

These create much more convenient and professional parts than using "captive nuts" (where you have to design a slot for a nut, and then place the nut in the slot and hold it there while affixing a screw). They also can be used in some situations where captive nuts just don't work.These are inserted into a hole in the p
These create much more convenient and professional parts than using captive nuts (where you have to design a slot for a nut, and then place the nut in the slot and hold it there while affixing a screw). They also can be used in some situations where captive nuts just don't work.

These are inserted into a hole in the print that is slightly smaller than the insert, and set in place using a soldering iron to melt the plastic around the insert. The inserts have a slight taper and small fins that the plastic flows around, resulting in an extremely strong bond.

Rather than adjust designs around the limitations of 3D printing (supports, print bed size, etc), divide your parts into separate components that fasten using these inserts and machine screws. Not only does this give you greater flexibility when designing a part, but also allows you to re-print only failed components rather than full assemblies - saving time and money.

These are threaded M5-0.8 with an overall length (OAL) .265
Recommended hole size is .315 (top) and .303 (bottom)
These create much more convenient and professional parts than using captive nuts (where you have to design a slot for a nut, and then place the nut in the slot and hold it there while affixing a screw). They also can be used in some situations where captive nuts just don't work.These are inserted into a hole in the print that is slightly smaller than the insert, and set in place using a soldering iron to melt the plastic around the insert. The inserts have a slight taper and small fins that the plastic flows around, resulting in an extremely strong bond.Rather than adjust designs around the limitations of 3D printing (supports, print bed size, etc), divide your parts into separate components that fasten using these inserts and machine screws. Not only does this give you greater flexibility when designing a part, but also allows you to re-print only failed components rather than full assemblies - saving time and money.These are threaded M5-0.8 with an overall length (OAL) .265Recommended hole size is .315 (top) and .303 (bottom)

Brass SMT INSERT M5 & M3, For Batteries at Rs 3.85/piece in Rajkot

Qty 500 M5 5mm M5-0.8 Long Metal Threaded Heat Set Screw Inserts for 3D Printing

International Online Shopping Store from US to Trinidad & Tobago

10Pcs Thread Reducing Nut Repairing Insert Kit Pipe Fitting Reducer Adapter Stainless Steel Fastener Accessory, Female M5 x 0.8mm, Male M8 x 1.25mm 12MM