Accueil
hotend ender 3
Ender-3 V2 Replacement Hotend (Assembled) – HartSmart Products

Ender-3 V2 Replacement Hotend (Assembled) – HartSmart Products

4.5 (354) · € 7.99 · En Stock

Genuine Creality MK8 Hotend Fully assembled MK8 hotend for Ender-3 V2 100% brand new and fully assembled so you can install it on your machine quickly and easily. Features:This MK8 assembled extruder hot end kit is compatible with the Ender-3/Ender-3s/Ender-3 ProComes with 0.4mm Nozzle, Aluminum Heat Block, Heat Sink,
Genuine Creality MK8 Hotend Fully assembled MK8 hotend for Ender-3 V2 100% brand new and fully assembled so you can install it on your machine quickly and easily. Features:This MK8 assembled extruder hot end kit is compatible with the Ender-3/Ender-3s/Ender-3 ProComes with 0.4mm Nozzle, Aluminum Heat Block, Heat Sink, PTFE Tube, Heater Cartridge, Thermistor with Pin Head and Throat Pipe, fully assembled, easy to install.White wire with pin head is the Thermistor, red wire is the Heater Cartridge (24V 40W).100% official Creality 3D productSpecifications:Works With: Ender-3 V2, Ender-3, Ender 3 ProNozzle Size: 0.4mmTube Length: Approx. 37cm LongThermistor and Cable Length: 130cmThroat Pipe Length: 30mmAluminum Block Size: Approx. 20 * 20 * 10mmOperating Temperature Range: -40~+260°C (-40~+500°F)

Creality Original 3D Printer Extruder Assembled MK8 Hot End Kit Ender 3 Hotend Replacement for Ender 3ender 3 Proender 3 V2 with Aluminum Heating

Genuine Creality MK8 Hotend, Fully assembled MK8 hotend for Ender-3 V2, 100% brand new and fully assembled so you can install it on your machine

Ender-3 V2 Replacement Hotend (Assembled)

Ender-3 Full Print Head

Firmware Pre-Installed Only for Ender3 V2 - Marlin 2.0.1 and firmware(not BLTouch version) for Ender-3 V2 comes pre-installed on this board. If your printer is Ender 3 v2 without BLtouch, you can install it to use directly. TMC ultra-silence chip effectively eliminates noise. Low-decibel operation keeps the motherboard running.

Creality Ender-3 V2 Silent Motherboard

This is an All Metal Hotend Kit for CR-10 Printers. This is a drop in All Metal Conversion kit for the CR10 printers. It requires absolutely zero modification to your printer to install. Our uniquely designed cooling block eliminates need for a thermal tube. By not having a separate thermal tube inside the cooling block, it allows for faster heat dissipation.